Panasonic KX-TVP200 Other Parameters-Fax Management, Have a call for mailbox owner’s name

B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS

Table B-34

Parameter	Value Range		Description/Function
	(Default)
Intercom	Up to 12 digits con-		Specifies the intercom paging sequence required by
Paging	sisting of 0-9,	, #	the PBX. This can be programmed using up to 12 of
Sequence	and special codes		the following 8 letters and 12 dial codes.
	(FXW)
			D: Disconnecting
			F: Flash (Recall)
			R: Ringback Tone Detection
			S: Silence Detection
			T: Dial Tone Detection
			W: Wait for 1 s
			X: Pager Dialling
			A: Answer
			1-9, 0, , #: Dial Digits
Release for	Up to 12 digits con-		Specifies the intercom paging release code required
Intercom	sisting of 0-9,	, #	by the PBX. This can be programmed using up to 12 of
Paging	and special codes		the 8 letters and 12 dial digits as specified above.
	(FW)
No Answer	1-30 s		Specifies the length of time (in seconds) the VPS must
Time for	(5)		wait before concluding Intercom Paging when there is
Intercom			no answer.
Paging
			The VPS will return to the caller if the paged party does
			not respond before this timer expires.
Announcement	1-3 times		Specifies the number of times to announce the
Repeat Cycle	(1)		intercom page.
			Example:
			"I have a call for (mailbox owner’s name)".
Intercom	1-10 times		Specifies the number of times to retry paging when the
Paging Retry	(2)		paging destination is busy or if there is no answer.
			Note: This setting applies only when the subscriber
			has enabled "Intercom Paging" in Incomplete Call
			Handling Status.
Paging Code	Up to 12 digits		Specifies the intercom paging access code required by
for Group 1-16	consisting of		the PBX.
	0-9, ,# for each
Paging Code
	group		Note: The Intercom Paging Group Number available
for All Groups
	(None)		for each subscriber is determined on a COS-by-COS
			basis.

Other Parameters-Fax Management

You can program the VPS to automatically forward incoming fax calls to a fax extension. You can specify a maximum of 2 fax extensions as the destination for the Automatic Fax Transfer.

Installation Manual 261