Panasonic KX-TVP200 Wait for Caller ID Wcid, Sample display, Type WCID, then Press Return

7.2 UTILITY COMMANDS

Sample display:

$ PUTD

Target Port for Debug : * * * * * * * * * * * *

Don't leave enabled after troubleshooting.

$

[1]DTMF:3

[1]DTMF:8

[1]A.Attend

[1]DTMF:#

[1]DTMF:6

[1]Voice Mail

[1]DTMF:1

[1]DTMF:0

[1]DTMF:1

[1]NonSub Svc

[1]* * *

[1]DTMF:#

[1]DTMF:9

[1]Thank you

WARNING

"PUTD" is a command originally used when troubleshooting. Do not use this command for any other purpose. Do not disconnect the RS-232C connection while the "PUTD" command is enabled. This could cause data overflow.

7.2.20 Wait for Caller ID (WCID)

Use the WCID command to specify the length of time (in seconds) the VPS must wait for the Caller ID after the VPS has received the incoming call from the PBX.

If Caller ID is not needed at all, set the waiting time to "0" to accelerate the VPS response to incoming calls.

Type WCID, then Press RETURN.

$ WCID

WAIT TIME FOR CALLER ID (5 sec) [0-60 sec] : = 0

$

162 Installation Manual