Panasonic KX-TVP200 Custom Service Programming, Disconnect Parameter, RS-232C Settings

5.2 PORT SETTING OPTIONS

This also allows an extension to be assigned as the fax manager to be notified on incoming faxes.

Disconnect Parameter (1-5-7-9)

Determines how many seconds of silence the VPS allows during a caller’s message before disconnecting the call.

RS-232C Settings (1-6-1)

Allows the System Administrator to change the baud rate, parity bit, etc.

Port Setting (1-6-2)

Only to be used when connecting the VPS to a PBX other than a KX-T series PBX. Use the CPC control of the PBX for normal disconnect problems.

Dialing Parameters (1-6-3-1)

These parameters are set automatically when Quick Setup is conducted.

Most of the settings will be left unchanged. The only setting that will be changed quite often is the Transfer Sequence for the operator or the extension. By default, it is set at FX on DPT Integration and FTX for Inband Integration. In other words, the voice processor dials the flash (recall), waits for intercom tone and dials the extension number. By default, the VPS will stay on the line to monitor the status of the call. If the extension user answers, the voice processor will announce "you have a call" prior to releasing the call. This can be alleviated by adding the letter "A" or "D" to the sequence. "A" stands for answer; the call will be transferred without the announcement "you have a call". For a blind or unscreened transfer, add the letter "D" for disconnect.

5.2.3 Custom Service Programming

After you have finished constructing the tree, enter the System Programming Custom Service Settings Menu.

Access the Custom Service Setting Menu through the following sequence:

System Administration Top Menu:

Enter The Number: = 1 (Program)

Enter The Number: = 4 (Service Setting)

Enter The Number: = 2 (Custom Service)

The system then asks what Custom Service number you want to edit. Enter the desired number (1-100).

The Custom Service screen is displayed:

116 Installation Manual