Belkin OmniView manual Device-Setup Software

2-3 Software Installation

Installation

Device-Setup Software

The software contained on the enclosed CD will help to configure the RIPM to your network so that you can access it remotely.

1.Connect the RIPM to your computer via local network. Start the setup tool from the CD-ROM on the computer where the RIPM is installed.

2.Follow the setup wizard to configure the RIPM. You will need to have the IP address, subnet mask, and gateway information that will be assigned to the RIPM. You may need to get this information from your network administrator. When the configuration has been completed, you will receive a “successful” notification. Your RIPM is now configured and can be accessed.

3.This CD-ROM also contains the software that is needed to transfer files between the local and remote computers. This will be covered in more detail in the “Virtual Media” section of this User Manual.

13