Brother FAX-8650P service manual EL Eraser Lamp Board

1.22 EL (Eraser Lamp) Board

Only when you need to replace the EL board (which is attached with double-sided adhesive tape), remove it according to the steps below.

(1)Make sure that the EL board harness is disconnected from the high-voltage power supply PCB. (Refer to Section 1.15.)

(2)Make sure that the heat-fixing unit is removed.

(3)Peel off the EL board from the main cover and clear adhesive tape if remaining.

nReassembling Notes

•When attaching a new EL board, bring the right end into contact with the boss provided on the main cover.

IV - 43