1.16Fan

(1)If the main PCB is installed, remove the screw from the main PCB (refer to Section 1.14).

(2)Slightly lift up the main PCB and disconnect the fan harness from the main PCB.

(3)Take out the fan support.

(4)Pull up the fan.

nReassembling Notes

Put the fan back into place with the non-sponge end facing up and with the label side facing outwards.

Route the fan harness through the harness guide as shown above.

IV - 36

Page 74
Image 74
Brother FAX-8650P service manual 16 Fan