Brother MFC 4350 manual Sending Faxes

200 C H A P T E R N I N E T E E N

Phone Line or Connections

Sending Faxes

DIFFICULTY	SUGGESTIONS
Dialing does not work	Check for a dial tone. Change TONE/PULSE setting
	(see “Tone/Pulse” p. 31). Check all line cord
	connections, and make sure the curled handset cord
	is not in the EXT jack. Check power cord
	connection. Send a manual fax by pressing Hook
	—OR—	by lifting the handset, and dialing the number.
	Wait to hear fax receiving tones before pressing Start .
MFC does not answer	Make sure the MFC is in the correct receiving mode
when called	for your setup (either FAX, FAX/TEL, TAD (for
	MFC 4350, MFC 4650 and MFC 7750) or MSG CTR
	(MFC 6650MC). Check for dial tone. If possible, call
	your MFC to hear it answer. If there is still no answer,
	check the telephone line cord connection. Connect a
	standard telephone handset to the MFC telephone jack.
	If there is no ringing when you call your MFC, call
	your Telephone Company to check the line.
No dial tone on the	Press Hook —OR—Lift the handset. If you hear no
handset	dial tone, check telephone line cord connections at
	the MFC and wall jack. Check that the handset curled
	cord is connected to the MFC's handset jack. Test the
	wall jack with another single line telephone. If no dial
	tone on the wall outlet, call your Telephone
	Company.
Poor transmitting quality	Try changing your resolution to FINE or
	SUPERFINE (see “Resolution” p. 64). Make a copy
	to verify the MFC’s scanner operation.
Transmission verification	There is probably temporary noise or static on the
report prints “Results:NG”	phone line. Try sending the fax again. If the
	problem continues, call the Telephone Company to
	check your phone line.
When the receiving party	Sometimes the resolution mode you chose when you
says the picture is	sent your fax may not have been appropriate. Send
not clear	the fax again, but try using the FINE or
	SUPERFINE mode. Also, your MFC’s scanner may
	be dirty, so try cleaning it (see page 213).
When the receiving party	Your MFC’s scanner may be dirty or the receiving
says vertical streaks	party’s	print head may be dirty. Clean your scanner,
appear on the faxes	(See page 213) and make a copy to check if the
they receive	problem was caused by your machine.