Brother MFC 4350 manual Remote Commands, Off

R E M O T E F A X O P T I O N S 83

Remote Commands

Follow the commands below to access features remotely. When you call the MFC and enter your Remote Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote control command.

Remote Control Commands			Operation Details
95	Changing Fax Forwarding/
	Paging setting
	1	OFF	If you hear one long beep, the change is
			accepted. If you hear three short beeps, you
	2	Fax Forwarding
			cannot change it because the conditions have
	3	Paging
			not been met. (Example: registering paging
	4	FAX FWD No.	number). You can register your fax forwarding
	6	Fax Storage ON	number by using 4. FAX FWD NO (see page
			95). Once you have registered the number, the
	7	Fax Storage OFF
			MFC will change automatically to FAX
			FWD:ON mode. Then retrieve a Memory
			Status List by entering 961 (see page 107) to
			make sure that the Fax Forwarding number you
			registered is correct on the List.
			You can set FAX STORAGE to ON or OFF.
96	Retrieve FAX
	1	Memory Status List	Enter the number of a remote fax machine to
			receive the Memory Status List or stored fax
	2	Retrieve all faxes
			message(s). (See page 107).
	3	Erase fax from	If you hear one long beep, you can erase fax
		the memory	message(s) from the memory.
97 Check the receiving status
	1	FAX	You can check whether your MFC has received
			any fax message(s). If yes, you will hear one long
			beep. If no, you will hear three short beeps.
98	Change Answer Mode
			If you hear one long beep, you can change the
	1	TAD
			Answer Mode. If you hear three short beeps, you
	2	FAX/TEL
			cannot change it.
	3	FAX
90	Exit		After a long beep, you can exit remote control.