Brother MFC 4350 manual Remote Control Commands

106 C H A P T E R T W E L V E

Remote Control Commands

Follow the commands below to access features remotely. When you call the MFC and enter your Remote Access Code (159 ), the system will signal you with two short beeps to enter a remote control command.

Remote Control Commands Operation Details

91Playing voice messages After one long beep, the MFC plays ICM and Memo.

								Press 1 while listening to an ICM or Memo message to play
				1			(Skip back)
								it again. If you press 1 before a message, you will hear the
								previous message.
				2			(Skip next)	While playing ICM and Memo, you can skip to next
								message.
				9		STOP Playing		Stop playing the ICM and Memo.
92					Record Memo			After one long beep, you can record a memo. You can stop
								recording by pressing 9.
	93 Erase all ICM & Memo							If you hear one long beep, the erase is accepted. If you hear
								three short beeps, you cannot erase because all voice messages
								have not been played, or there is no voice message to erase.
								*This code erases all recorded messages, not one at a time.
	94 Play and Record OGM
					in memory
	1 Play						1 MSG CTR OGM	The MFC plays the selected OGM. You can stop playing
								OGMs by pressing 9.
							2 F/T OGM
	2	Record					1 MSG CTR OGM	After one long beep, you can record the selected OGM. You
								will hear the message played once. You can stop recording
							2 F/T OGM
								the message by pressing 9.
95					Changing Fax Forwarding/			If you hear one long beep, the change is accepted. If you hear
					Paging setting			three short beeps, you cannot change it because the conditions
					1	OFF		have not been met (Example: registering paging number). You
								can register your fax forwarding number by using 4. FAX
					2	Fax Forwarding		FWD NO (See page 108). Once you have registered the
								number, the MFC will change automatically to
					3	Paging
								“FAXFWD:ON” mode. Then retrieve a Memory Status List by
					4	FAX FWD NO.		entering 961(See page 107) to make sure that the Fax
								Forwarding number you registered is correct in the list.
96					Retrieve Fax			Enter the number of the remote fax machine to receive a
			1			Memory Status List		report or stored fax message.
			2			Retrieve all faxes
			3			Erase fax from the		If you hear one long beep, you can erase the fax message
						memory		from the memory.
	97 Check the receiving status							You can check whether your MFC has received any FAX or
				1		FAX		VOICE messages. If yes, you will hear one long beep. If no,
								you will hear three short beeps.
				2		VOICE
98					Change Answer Mode			If you hear one long beep, you can change the answer mode.
								If you hear three short beeps, you cannot change it.
			1			MSG CTR
								(Example: When there is no MSG CTR OGM and you tried
			2			FAX/TEL
								to change to MSG CTR mode.)
			3			FAX
90					Exit			After a long beep, you can exit remote control.