Using the Focal Length Guide

Using the Focal Length Guide

The focal length guide aids you when using two camcorders for 3D recording. The guide appears as a numerical value and has a range of 202 steps. You can set the guide to 0 at any point in the zoom range to help precisely

128calibrate both camcorders.

Operating modes:

1

Set up two camcorders and align their picture angle at full

 

[~Camera Setup]

 

telephoto.

2

Open the [Focal Length] submenu.

[Zoom]

 

[~Camera Setup] >[Zoom] >[Focal Length]

 

 

3

Select [Set To 0] and then press SET.

[Focal Length]

 

 

4

Press MENU.

 

 

• The focal length guide appears on the left of the screen as [ ±0].

[Off]

 

To turn off the indicator, select [Off] instead.

 

 

 

5

Operate the zoom.

 

 

• If both camcorders are set so that the same value is displayed during zoom, the focal length for both

 

camcorders will remain almost the same.

 

NOTES

•Although the focal length guide is an aid for 3D recording, make sure to check the picture angle visually while recording.

•You can obtain more accurate results when you perform this procedure at full telephoto.

•The same picture angle for both camcorders cannot be guaranteed.

•When using the digital tele-converter or digital zoom

-When the focal length is reset to zero, the digital tele-converter or digital zoom is deactivated and [~Camera Setup] >[Zoom] >[Mode] is set to [Normal] (optical zoom only).

-If the focal length was reset to zero while the zoom was in the digital zoom range, the zoom position will change automatically to the telephoto end of the optical zoom.