Custom Picture Settings

[Knee]

Controls the upper part of the gamma curve (highlights of the image). By compressing the highlights, you can prevent parts of the image from being overexposed. When [Gamma] is set to [Cine 1], [Cine 2] or [Wide DR], this setting has no effect on the picture.

[Enable]:

Activates/deactivates the setting. (Default: [On])

[Automatic]:

Select [On] to have the camcorder automatically set the knee point and slope to prevent images

 

being overexposed so quickly. Select [Off] to manually adjust the knee point. (Default: [On])

[Slope]:

Determines the slope of the gamma curve above the knee point. This setting can be adjusted

 

from -35 to 50. (Default: ±0)

 

[Point]:

Sets the knee point of the gamma curve. This setting can be adjusted from 50 to 109.

 

(Default: 95)

 

[Saturation]:

Adjusts color saturation in highlights. This setting can be adjusted from -10 to 10. (Default: ±0)

 

Knee Slope

Knee Point

137

English

Output

Output

Input

Input

[Sharpness]

Sets the sharpness of the output and recording signal.

[Level]:

Sets the sharpness level. This setting can be adjusted from -10 to 50. (Default: ±0)

[H Detail Freq.]: Sets the center frequency of horizontal sharpness. Setting higher values increases the frequency, which, in turn, increases the sharpness. This setting can be adjusted from -8 to 8. (Default: ±0)

[Coring]:

Reduces noise artifacts caused by high sharpness levels.

[Level]: Sets the coring level. Higher values prevent sharpness from being applied to minute details, resulting in less noise. This setting can be adjusted from -30 to 50. (Default: ±0)

[D-Ofst]: You can use [D-Ofst], [D-Curve] and [D-Depth] to adjust the coring level based on brightness. [D-Ofst] sets the coring level of the minimum brightness level. This setting can be adjusted from 0 to 50. (Default: 0)

[D-Curve]: Sets the curve of the coring adjustment. This curve is the change from [Level] to [D-Ofst]. This setting can be adjusted from 0 to 8. (Default: 0)

[D-Depth]: Sets a multiplier to [D-Ofst] that determines the coring level adjustment based on brightness. Positive values raise the coring level in dark areas and negative values lower the level. This setting can be adjusted from -4 to 4. (Default: ±0)

[HV Detail Bal.]: Adjusts the ratio between horizontal and vertical detail. Higher values emphasize vertical detail while lower values emphasize horizontal detail. This setting can be adjusted from -8 to 8. (Default: ±0)

[Limit]:

Restricts how much sharpness is applied. This setting can be adjusted from -50 to 50.

 

(Default: ±0)