Chapter 3 Basic Operation

1. Turning the Power ON and OFF

Use the power switch to turn the DR-X10C scanner ON and OFF, or if you are using a USB connection, you can set the USB-linked power switch.

CAUTION

•After turning the scanner OFF, wait at least ten seconds before turning it back ON.

•If the scanner is connected via SCSI cable, always turn the scanner ON before turning the computer ON. If you turn the computer ON before the scanner, it may not recognize the scanner properly.

About the Power Switch

When the power switch (located at the lower left side of the front of the scanner) is turned ON, the Document Feed Tray opens automatically. (See p. 3-6.)

Power Switch

■USB-Linked Switch Setting (with USB connection only)

To set to have the computer’s power switch turn the scanner ON and OFF as well, you can enable the Auto USB Power Off function.

You can change the “Auto USB Power Off” setting using the User Mode.

1.Press the Menu key on the control panel.

Menu Key

The User Mode is activated.

2.Press the [] key five times to display “Auto USB PWR OFF”. (See p. 4-9.)

3.Confirm your settings.

ON: When a USB cable is connected, the scanner’s power switches ON and OFF according to the computer’s power state.

OFF: The scanner’s power turns ON and OFF by its power switch.

3-2