Problem 3: Error message appears during print job.

Solution: When an error message appears in the printer operation panel or the Windows display, read the message in the GARO Status Monitor, or in the GARO Printermonitor for Macintosh. Then correct the problem.

(Æ P.7-13)

Problem 4: No print media loaded.

Solution: Replenish the print media in the designated feed source.

Problem 5: The “Media Size” and “Media Type” selections are not selected.

Solution: Use the printer operation panel to select the correct setting for the media type. (Æ P.2-8,P.2-19)

Solution: If the Media Type selection is incorrect, cancel the print job, open the printer driver and select the correct setting for the print media loaded. (Æ P.3-4,P.4-7)

Problem 6: Ink has run out, or the printhead nozzles are clogged.

Solution: Print a nozzle check pattern and check the ink supply and the condition of the printhead.

If the ink supply has run out in one or more ink tanks, replace them. (Æ P.6-2)

If the nozzles are clogged, clean the printhead. (Æ P.7-33)

Ink initialization operation starts unexpectedly.

Problem 1: When the printer was switched off previously, this force cancelled a cleaning operation.

Solution: Wait for the ink initialization operation to finish. Ink initialization may require up to 30 minutes to finish.

Printing Halts During Print Job

Error message is displayed.

Problem 1: An error message is displayed during printing.

Solution: Read the message displayed in the GARO Status Monitor or GARO Printmonitor, and correct the problem indicated by the error message. (Æ P.7-13)

Problem 2: The specified Media Source is not correct for the media loaded in the paper supply source.

Solution: Confirm the current selection for the Media Size. If the setting is not correct, stop the print job, select the correct setting, then start the print job again. (Æ P.2-8,P.2-19)

Printer Not Operating Correctly 7-7