Switching the Printer On and Off
Follow the procedure below to switch the printer on and off.
The examples below demonstrate normal operation of the printer after it is set up and ready for normal operation. If the printer has not been set up completely, follow the procedures in the Setup Guide to complete the setup procedures before you execute the procedures below.
Switching the Printer On
Switch on the printer before you execute a print job from the computer.
1 Press the Power button.
| |||
|
|
|
|
|
|
|
|
|
The Online lamp and Message lamp flash for a few seconds while the printer warms up. After the printer has warmed up, if media is loaded in the printer the Online lamp lights and remains on, and “Online” is displayed. The printer is ready to print.
Paper Source | Data | Message | Power |
Roll Media |
|
|
|
Cut Sheet | Online |
|
|
|
|
| |
Cancel |
| Enter | Online |
If no print media is loaded in the printer when the printer is switched on, “Offline” is displayed and the printer waits for you to load media in the printer.
The Message lamp flashes when a message is displayed. Read the message and perform the required procedure. (Æ “Message Is Displayed”
If the display or Online lamp do not light, check the power cord connections at the printer and the power supply and make sure that they are secure.
(Æ Setup Guide)
Switching the Printer On and Off