Feed Limit
Problem 1: You pressed on the operation panel to feed more media than allowed.
Solution: Open the tray, then turn the roll holder manually to feed the extra media.
Size Undetected
Problem 1: The media has shifted out of the correct load position, or the media is curled.
Solution: Set the media correctly. (Æ
Problem 2: The printer interior is dusty or dirty.
Solution: Open the upper cover and clean inside the printer. (Æ
Remove Ink Tank
Problem 1: Right cover was closed without removing the ink tank.
Solution: Remove the ink tank.
Turn Power Off!!
Problem 1: The tape inside the upper cover or the belt stopper have not been removed.
Solution: Switch the printer off, open the upper cover, remove the tape and belt stopper, then press the Power button. (Æ Setup Guide)
Problem 2: The printer has malfunctioned.
Solution: Switch the printer off, then press and hold down the Power button for over 3 seconds to switch the printer on again.
Solution: If the message occurs again after switching the printer off and on, note the message in the first line of the operation panel display, then call for service.
Problem 1: The waste ink tank is nearly full and requires replacing very soon.
Solution: Printing can continue after this message is displayed. However, you should call for service as soon as possible before a Service Call is issued.
Message Is Displayed