Casio IT-2000W manual Operations, Send File to PC one file transmission from IT-2000 to PC

Operations

(1) SEND FILE TO HT (one file transmission from IT-2000 to IT-2000)

This function may be available in future (as of now, not available). It is not allowed to use the function. If the file transmission between IT-2000s is needed, FLINK utility may be used (refer to Chapter 3.11 “FLINK Command”.).

(2) SEND FILE TO PC (one file transmission from IT-2000 to PC)

This function is used to copy an optional file from an IT-2000 to PC. To do this, use commercial terminal emulation software on the PC side. The destination directory of this copy should be specified by the terminal emulation software on the PC side.

Connect one end of the serial cable (cross-type) to the 8-pin COM port of the IT-2000 and connect the other end to the COM port of the PC.

Select "SEND FILE TO PC" on the transmission side.

On the PC side initiate the terminal emulation software to prepare for download. Select a baud rate of 9600 bps, and specify the YMODEM Batch protocol.

When the file name input screen appears on the IT-2000 side, specify the transmitted file with its full path name (including the drive name), then press the “RET” key.

Pressing the “RET” key starts file transfer. When the "Normal End" message is displayed, file

￿transmission has been completed.

If the “CLR” key is pressed during file transfer, transfer will be interrupted. It will take about 10 seconds for communication to completely stop.

(3) SEND ALL TO HT (transfer all files in the user drive of IT-2000 to IT-2000)

This function may be available in future (right now, not available). It is not allowed to use the function. If the file transmission between IT-2000s is needed, FLINK utility may be used (refer to Chapter 3.11 “FLINK Command”.).

(4)RECEIVE FILES (file reception)

The function is used to receive one file from the PC. On the PC side commercial terminal emulation software can be used. In this operation the copy destination directory cannot be specified.

Connect one end of the serial cable (cross-type) to the 8-pin COM port of the IT-2000 and connect the other end to the COM port of the PC.

￿Move the cursor to " RECEIVE FILES ", then press the “ RET” key to prepare for reception. Start upload with the terminal emulation software on the PC side.

Select a baud rate of 9600 bps, and specify the YMODEM Batch protocol.

63