Casio IT-2000W manual Operation

Note:

If the identical file name exists on the reception side, this command overwrites the existing file.

At this time, the system does not unconditionally overwrite the existing file but creates a temporary file on the reception-side disk and attempts the overwrite after file transmission has been competed. This protects file data even if transmission of the file fails.

Therefore, if the identical file name exists on the reception side, the reception-side disk must have a space large enough for the transmitted file. If there is insufficient space, either delete unnecessary files in advance on the reception side or use the file delete command (on page 253) to delete them.

Operation

SEND FILE to HT (One file transmission from IT-2000 to IT-2000)

This function is used to copy one file from one IT-2000 to another IT-2000. This file will be copied to a destination directory that has a name that is identical to the source directory.

Place the two IT-2000 units so that their IR windows face each other.

Select "SEND FILE TO HT" at the transmission side.

Select "REMOTE SERVER" at the reception side to prepare for reception.

If the file name input screen appears at the transmission side, specify the transmitted file by its

￿full pathname (including the drive name), then press the “ RET” ke y.

Press the ”RET” ke y to start file transfer. If the "Normal End" message is displayed, file transmission has been completed.

Note:

If the “C LR” ke y is pressed during file transfer, transfer will be interrupted. It will take about 10 seconds for communication to completely stop.

SEND ALL to HT (Transfer of all files in the F-ROM drive of IT-2000 to IT-2000)

This function is used to mirror-copy the F-ROM drive. All files existing on the F-ROM drive of the copy source side are copied to the F-ROM drive of the destination side. Since this process does not attempt either file deletion or formatting on the copy destination side, it is necessary to confirm in advance that the F-ROM drive of the destination side has sufficient free space.

Place the two IT-2000 units so that their IrDA interface windows face each other. Select "REMOTE SERVER" on the reception side to prepare for reception.

On the transmission side move the cursor to "SEND ALL TO HT" and press the “ RET” ke y.

￿File transfer begins.

If the "Normal End" message is displayed, file transmission has been completed.

66