Casio IT-2000W manual Installation of MS-Windows, Demonstration Installation

5.2Installation of MS-Windows

As explained on the previous page, it is necessary to move (copy) some files onto the write-permit drive before booting MS-Windows. This section will describe this copy operation The following is an example of manually installing necessary files so that the user can determine the contents.

A utility program (WINST.EXE) can be used to reduce the work load.

For more information about this installation utility refer to Chapter 9.10 "Windows Installation Utility".

5.2.1Demonstration Installation

For this terminal it is recommended to initiate the application program at the same time MS-Windows is started. The program manager can also be initiated during the development of application programs or for the purpose of demonstration. To initiate the program manager for the above purpose use the following procedure:

￿Create the D:￿WINDOWS directory.

Copy the entire content of E:￿WINDOWS￿LOCAL onto the created directory. The following files are to be copied:

	WIN.COM	WIN.INI
	WIN.CLN	WFWSYS.CFG
	SYSTEM.INI	MOUSE.INI
	PROGMAN.INI	SERIALNO.INI
	CONTROL.INI	MAIN.GRP
	ACCESSOR.GRP	STARTUP.GRP
	WINVER.EXE	SYSTEM.CLN
￿	SHARES.PWL

Create the CONFIG.SYS and AUTOEXEC.BAT files. Remember to add "D:￿WINDOWS;

E:￿WINDOWS" to the existing path. Then specify “win.com” to boot MS-Windows at the end

￿of the AUTOEXEC.BAT file.

Copy the created CONFIG.SYS and AUTOEXEC.BAT files onto D:￿.

The above procedures complete the demonstration installation of MS-Windows. MS-Windows will be automatically booted if the terminal is re-started by pressing the RESET switch.

85