Casio IT-2000W manual Remote Server remote server mode, About communication with PC

Note:

If the “CLR” key is pressed during file transfer, transfer will be interrupted. It will take about 10 seconds for communication to completely stop.

REMOTE SERVER (remote server mode )

The remote server mode is used by the system which assigns the right of issuing a transmission request to the partner side and enters the wait state for a request from the partner.

To facilitate communication between two IT-2000 terminals, set the reception side to this mode. For HT-to-PC communication set the IT-2000 side to this mode and perform the entire operation on the PC side.

￿Move the cursor to "REMOTE SERVER" and press the “ RET” key.

If the "Hit Any Key!" message appears, file transmission has been completed.

Note:

If the “CLR” key is pressed during file transfer, transfer will be interrupted. It will take about 10 seconds for communication to completely stop.

About communication with PC

To achieve communication between a PC and IT-2000 it is necessary to prepare an I/O Box for IT-2000 and PC-side communication utility "LMWIN.EXE (Windows version)". The following procedure shows the steps required for communication with a PC.

Connect the I/O Box and PC using a communication cable. Turn on the power of I/O Box. Mount the IT-2000 on the I/O Box.

Select "REMOTE SERVER" on the IT-2000 side to enter the wait state.

￿On the PC side initiate the PC-side communication utility, LMWIN.EXE.

Operate the PC-side communication utility to perform reception or transmission. For information about the operation of the PC-side communication utility refer to the "IT-2000 Upload/Download

￿Utility Manual" available separately.

If the "Hit Any Key!" message appears on the IT-2000 side, file transmission has been completed.

Note:

If the “CLR” key is pressed during file transfer, the transfer will be interrupted. It will take about 10 seconds for communication to completely stop.

67