9.7XY Utility

Overview

The XY utility is used to perform communication either between an IT-2000 and PC, or between two IT-2000 terminals by means of XMODEM or YMODEM BATCH protocol.

This utility is provided as a DOS application and should be activated as a command line or as child-process of the application program.

File name:

XY.EXE

Function

Transmission of a file

Transmits a file.

Reception of a file

Receives a file.

Selection of a protocol

Select either XMODEM protocol or YMODEM-BATCH protocol.

Specification of the

Select the error check method as the checksum or CRC method.

error check method

 

Specification of a

Select the packet length as 128 or 1024 bytes.

packet length

 

Specification of a baud

Select a baud rate between 1200 and 115200 bps.

rate

 

Transmission of

By using a wild card it is possible to transmit multiple files at one time.

multiple files

In addition, files included in the sub- and deeper directories can be

(only for YMODEM)

transmitted.

Startup Method

This utility is supplied on drive (C:). Usually this utility is made available after it is called from the system menu as a child process. However, it can be used either as a single command or as a child process to be called from another application.

Note:

When the cable comes off while the communication takes place:

If the connection cable is accidentally unplugged while communication between the IT-2000 and PC is taking place, a communication error results and communication is interrupted. In this case the communication software on the PC will display an error message and interrupt transmission/reception, however, some data may remain in the transmission buffer. If an attempt is made to restart communication in this condition, the XY utility will receive illegal packets, hampering normal communication. If this occurs, terminate the communication software on the PC side then restart it to restore normal communication.

277

Page 277
Image 277
Casio IT-2000W manual XY Utility, Overview