Casio IT-2000W manual Evenparity, Markparity, Nonparity, Oddparity

The DCB structure defines the control setups of serial communication.

<Members >

Id	Identifies the communication device. This value is set by the device driver.
	If the most significant bit (MSB) is set, the DCB structure is used for a parallel
	communication device.
BaudRate	Indicates the baud rate representing the processing speed of the communication
	device. If the upper byte is 0xFF, the lower byte indicates the baud rate index
	This index takes one of the following
values	CBR_9600, CBR_19200, CBR_38400, CBR_56000, CBR_128000, and
	CBR_256000. If the upper byte is has a value other than 0xFF, this parameter
	indicates the actual baud rate. If a baud rate index other than one described above
	is used, SetCommState results in error. This function operates only if both
	the 9-Wire and 3-Wire connections are established.
ByteSize	Indicates the number of bits to be transmitted/received. The value of the ByteSize
	member ranges between 5 and 8. A value of 4 is not supported.
	This function operates if both the 9-Wire and 3-Wire connections are established.
Parity	Indicates the parity check method to be used. This member takes one of the
	following values. This function operates if both the 9-Wire and 3-Wire
	connections are established.
	EVENPARITY	Even number
	MARKPARITY	Mark
	NONPARITY	No parity check
	ODDPARITY	Odd number
StopBits	Indicates the number of stop bits to be used. This member takes one of the
	following values. A value of 1.5 bits is not supported. This function operates if
	both the 9-Wire and 3-Wire connections are established.
	ONESTOPBIT	1 bit
	TWOSTOPBITS	2 bits
RlsTimeout	Not supported.
CtsTimeout	Not supported.
DsrTimeout	Not supported.
fBinary	Indicates the binary mode. Non-binary mode is not supported.
fRtsDisable	Indicates whether to disable the RTS (request to send) signal. If the fRtsDisable
	member is set, the RTS signal will be kept being turned off. Or, the member is
	cleared, the signal will be turned on if the device is opened, and will be turned off
	if the device is closed. This function operates if the 9-Wire connection is
	established.
fParity	Indicates whether or not to perform a parity check. If the fParity member is set,
	the parity check is performed and an error is reported, if one occurs.
	This function operates if both the 9-Wire and 3-Wire connections are established.

130