Casio IT-2000W manual DEVICE=C HIMEM.SYS /M2

￿￿￿￿￿

(1)DOS=HIGH,NOUMB

This specifies that the main part of DOS is to be loaded in the HMA and, consequently, the UMB (Upper Memory Block) is not used. This terminal does not support a memory space for UMB if the EMS memory is to be used. Therefore, always specify NOUMB when using the EMS.

(2)DEVICE=C: SYSDRV.SYS

This driver is required to operate this terminal. Always install it before all other drivers.

(3)DEVICE=C: HIMEM.SYS /M:2

Never fail to specify the "/M:2" option.

(4)DEVICE=C: POWER.EXE

DEVICE=C:￿TIME.SYS

This driver is required to enable the APM function. TIME.SYS must follow immediately after POWER.EXE.

(5)DEVICE=C:￿EMM386. EXE FRAME=C800 X=C000-C7FF X=D800-DFFF I=C800-D7FF

Always specify the above options if using the EMS. Options other than the X option can be eliminated if the EMS is not used.

(6)DEVICE=C: CARDSOFT SS365SL.EXE /SKT=1

DEVICE=C: CARDSOFT CS.EXE /POLL:1

DEVICE=C: CARDSOFT CSALLOC.EXE

DEVICE=C: CARDSOFT ATADRV.EXE /S:1

DEVICE=C: CARDSOFT MTSRAM.EXE

DEVICE=C: CARDSOFT MTDDRV.EXE

DEVICE=C: CARDSOFT MTDAPM.SYS

DEVICE=C:￿CARDSOFT￿CARDID.EXE

INSTALL=C:￿CARDSOFT￿CS_APM.EXE

This driver is required if the PC card driver is used. However, if the SRAM card is not used, the lines following ATADRV.EXE can be modified as follows. This saves a memory space as large as that used for the SRAM card driver. For more information refer to Appendix B "PC Card Driver".

DEVICE=C: CARDSOFT ATADRV.EXE /D:1

DEVICE=C: CARDSOFT MTDAPM.SYS

DEVICE=C:￿CARDSOFT￿CARDID.EXE

INSTALL=C:￿CARDSOFT￿CS_APM.EXE

79