Operations | MediaVault 4105 User Manual |
TABLE 5-2. Description of the Front Panel Components.
Component | Description | |
|
| |
Power | “On” indicates that the unit is powered up and ready for operation. | |
This indicator will flash rapidly for 20 seconds during the initial | ||
| ||
|
| |
| “On” indicates that the MV 4105 is operating in a RAID 3 protected mode. See the | |
RAID 3 | “Mode (RAID Type) Functions” section in this chapter for additional RAID type | |
information. | ||
| ||
| When this indicator is off, the MV 4105 is operating in RAID 0 (performance) mode. | |
|
| |
| These LEDs indicate drive activity or drive fault. | |
D1 to D5 (Drive 1 | The LEDs will illuminate as the disk drives are being accessed. The LEDs are off | |
when there is no drive activity. | ||
to Drive 5) | ||
| ||
| In a fault condition, associated with the Service LED and an audible alarm, the faulty | |
| drive is identified by a slow blinking drive LED. | |
| “On” indicates that the Fibre Channel interface is operating at its optimum 4Gbit | |
| speed. | |
4Gb | When this indicator and the 2Gbit indicator are off, the MV 4105 is operating at less | |
| ||
| than 2Gbit speed. | |
|
| |
| “On” indicates that the Fibre Channel interface is operating in 2Gbit speed. | |
2Gb | When this indicator and the 4Gbit speed indicator are off, the MV 4105 is operating at | |
| ||
| less than 2Gbit speed. | |
|
| |
| “On” indicates that the MV 4105 needs to be serviced. Normally this LED is | |
Service | associated with an audible alarm. One of the drives LED will flash slowly. A drive | |
| replacement might be necessary. See the “Audible Alarm” section on page |
MV 4105_Ciprico Inc. |
