
MediaVault 4105 User Manual | Operations |
Mode Set Button
This switch performs several functions:
•During power up, it acts as a Mode Set switch.
•During normal operation it is used to Silence Alarms and to start the rebuild process for a replaced drive.
During the first 20 seconds of power up, the switch acts as a Mode Set switch and is used in conjunction with the Mode Selection option. See the “Mode Change Procedure” on page
During normal operation, and only when the MV 4105 is in the RAID 3 modes, this switch is used to silence alarms and to start a drive rebuild process. When a defective drive has been replaced, this rebuild process brings the MV 4105 back up to its fully protected mode. See the “Audible Alarm” section on page
TABLE 5-6. Mode Set Button Functions
Indicator | Description |
|
|
Mode Set Button | Used during the RAID “Mode Change” procedure (see page |
(for Mode changes) | Press and hold this switch and apply power to the MV 4105. A double beep confirms |
| |
| the mode change. |
| Release the switch after the double beep. The new Mode selection is now set. |
|
|
Mode Set Button | Mutes the audible alarm when the MV 4105 requires service. Do a quick press & |
| release to mute the alarm. |
|
|
Mode Set Button | In RAID 3 mode, and when a drive is marked as “down,” this switch is used to start |
(for drive rebuilds) | the drive rebuild process. |
| After the alarm has been muted, press and hold the Mode Set button until you hear |
| two beeps. The rebuild process has now started. |
| See the “Audible Alarm” section on page |
| (in Chapter 8, Maintenance) for additional information. |
|
|
MV 4105_Ciprico Inc. |