Ciprico 4105 Series user manual Rear Panel Components

Operations MediaVault 4105 User Manual

TABLE 5-3.Rear Panel Components.

Component	Description
	FC Port 1 and FC Port 2 (on Side A or Side B) can accept a Fibre Channel SFP with
FC Port 1,	an LC Duplex optical cable.
FC Port 2	See “Fibre Channel Connections” in Chapter 4, Installation.
MODE SELECT	Used to change the mode (RAID type) number. See “Mode (RAID Type) Change
	Procedure” on page 5-12.
Unit Fan	Vents heat from the interior of the MV 4105.
DIAG	The Diagnostic port is used to enable firmware downloads or perform special
	diagnostics. See “DIAG - Diagnostic Port” in Chapter 4, Installation.
	In the “On” (1) position, the power switch provides power to the MV 4105.
Power On/Off	In the “Off” (0) position, the MV 4105 is powered-off.
	To completely remove power from the MV 4105, disconnect the power cable from the
	power cable receptacle.
MODE SET	A multi-function button. See the description in the “Mode Set Button” section on
	page 5-13.
Receptacle,	Power receptacle for 100-240 Vac power cable to the auto-ranging power module
Power Cable	(power supply).
Fan, Power Supply	Vents heat from the power supply.
	LINK LED: Indicates that communications are established between the Fibre
	Channel microprocessor inside the MV 4105 and the built-in hub of the MV 4105.
Hub LEDs	SYNC LED: Indicates that the FC speed is established between the built-in hub
	portion of the MV 4105 and the device to which this port is connected.
	ACTIVE LED: Indicates that data is being transmitted.

5-6 MV 4105_Ciprico Inc.