3-85
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Procedures
PLATFORM_IPv6 Message
Error Message PLATFORM_IPC-3-MEMBER: [chars].
Note This message applies only to Catalyst 3750 and 2975 switches.
Explanation There has been an IPC failure on a stack member switch. [chars] describes the er ror
message.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with th e gathered
information. For more information about these online tools and about contacting Cisco, see the “Error
Message Traceback Reports” section on page 2-7.
Error Message PLATFORM_IPC-3-STACK_EVENT: [chars].
Note This message applies only to Catalyst 3750 and 2975 switches.
Explanation There has been an IPC failure in the stack. [chars] describes the error message.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with th e gathered
information. For more information about these online tools and about contacting Cisco, see the “Error
Message Traceback Reports” section on page 2-7.
PLATFORM_IPv6 Message
This section contains the IP Version 6 message.
Error Message PLATFORM_IPv6_UCAST-6-PREFIX: One or more, more specific prefixes
could not be programmed into TCAM and are being covered by a less specific prefix
Note This message applies 3750, 3560, 2975, and 2960 Platforms.
Explanation A more specific prefix could not be programmed into Ternary Content Addressable
Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The
output of the show platform ipv6 unicast retry route privileged EXEC command lists the failed
prefixes.
Recommended Action No action is required.