3-122
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Proced ures
SPANTREE Messages
Error Message SPANTREE-2-PVSTSIM_OK: PVST Simulation inconsistency cleared on port
[chars].
Explanation The specified interface is no longer receiving PVST BPDUs advertising information
that is inconsistent with the CIST port information. The PVST simulation inconsistency is cleared,
and the interface returns to normal operation. [chars] is the port.
Recommended Action No action is required.
Error Message SPANTREE-2-RECV_1Q_NON_1QTRUNK: Received 802.1Q BPDU on non 802.1Q
trunk [chars] [chars].
Explanation The listed interface on which a Shared Spanning Tree Protocol (SSTP) BPDU was
received was in trunk mode but was not using IEEE 802.1Q encapsulation. The first [chars] is the
port, and the second [chars] is the VLAN.
Recommended Action Verify that the configuration and operational state of the listed interface and
that of the interface to which it is connected are in the same mode (access or trunk). If the mode is
trunk, verify that both interfaces have the same encapsulation (ISL or IEEE 802.1Q). If the
encapsulation types are different, use the switchport trunk encapsulation interface configuration
command to make them consistent. When the encapsulation is consistent, spanning tree
automatically unblocks the interface.
Error Message SPANTREE-2-RECV_BAD_TLV: Received SSTP BPDU with bad TLV on [chars]
[chars].
Explanation The listed interface received an SSTP BPDU without the VLAN ID tag. The BPDU is
discarded. The first [chars] is the port, and the second [chars] is the VLAN that received the SSTP
BPDU.
Recommended Action If this message recurs, copy the message exactly as it appears on the console
or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Use
the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the “Error Message Traceback Reports” section on page 2-7.
Error Message SPANTREE-2-RECV_PVID_ERR: Received BPDU with inconsistent peer vlan id
[dec] on [chars] [chars].
Explanation The listed interface received an SSTP BPDU that is tagged with a VLAN ID that does
not match the VLAN ID on which the BPDU was received. This occurs when the native VLAN is
not consistently configured on both ends of an IEEE 802.1Q trunk. [dec] is the V LAN ID, the first
[chars] is the port, and the second [chars] is the VLAN.
Recommended Action Verify that the configurations of the native VLAN ID is consistent on the
interfaces on each end of the IEEE 802.1Q trunk connection. When the configurations are
consistent, spanning tree automatically unblocks the interfaces.