3-76
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Proced ures
PBR Messages
Error Message PBR-3-UNSUPPORTED_RMAP: Route-map [chars] not supported for
Policy-Based Routing
Note This message applies only to Catalyst 3550 switches.
Explanation The route map attached to an interface for policy routing contains an action that is not
supported on this platform. This is a hardware limitation. [chars] is a value that is applied by using
the route-map interface configuration command.
Recommended Action Reconfigure the route map. Use only permit entries and set ip next-hop action
in the route map.
Error Message PBR-4-CPU_SUPPORTED_ACTION: Set action in sequence [dec] of route-map
[chars] supported by forwarding to CPU.
Note This message applies only to Catalyst 3550 switches.
Explanation The route map attached to an interface for policy routing contains an action that is not
supported in hardware because it contains set interface, set ip default next-hop, set default interface
or set ip df actions. The packets must be forwarded by the CPU. [dec] and [chars] are values that are
applied by using the route-map interface configuration command.
Recommended Action Reconfigure the route map. If possible, use only set ip next-hop in the route
map.
Error Message PBR-3-INSTALL_FAIL: Policy route-map [chars] not installed in hardware
Note This message applies only to Catalyst 3550 switches.
Explanation The PBR manager was unable to install the complete route map in the hardware, so this
will have to be applied in software. The packets must be forwarded by the CPU. [c hars] is a value
that is applied by using the route-map interface configuration command.
Recommended Action Reconfigure the route map to use a simpler configuration. If possible, use the
same route map on multiple interfaces.
Error Message PBR-4-RETRY_INSTALL: Route-map [chars] installed in hardware upon
retry
Note This message applies only to Catalyst 3550 switches.
Explanation The PBR manager was able to fit the complete configuration into the hardware. One or
more route maps had previously not been loaded because of lack of space. [chars] is a value tha t is
applied by using the route-map interface configuration command.
Recommended Action No action is required.