3-75
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Procedures
PBR Messages
Error Message %PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]
registry
Explanation The switch could not add a function to the r egistry. [chars] is the registry name.
Recommended Action No action is required.
PBR Messages
This section contains the policy-based routing (PBR) messages.
Error Message PBR-2-NO_RMAP: Cannot create PBR data structures for route-map [chars]
Note This message applies only to Catalyst 3550 switches.
Explanation The PBR manager could not allocate the data struct ures needed to describe a route map
being used for policy routing. This was probably caused by l ack of available memory. [chars] is a
value that is applied by using the route-map interface configuration command.
Recommended Action Use a less-complicated configuration that requires less memory.
Error Message PBR-3-NO_LABEL: Cannot allocate label for route-map [chars]
Note This message applies only to Catalyst 3550 switches.
Explanation The PBR manager could not allocate a label for this route map. This means that the
hardware cannot be programmed to implement policy routing. There is a limit of 247 labels for
policy routing. [chars] is a value that is applied by using applied the route-map interface
configuration command.
Recommended Action Use a less complicated configuration that allows label sharing. If possible, use
the same route maps on multiple interfaces.
Error Message PBR-3-MERGE_FAIL: [chars] ACL merge error [dec] on route-map [chars]
Note This message applies only to Catalyst 3550 switches.
Explanation The PBR manager could not complete the merge of the configu red route map into a form
suitable for loading into the hardware. The most likely cause is specifying an access control list
(ACL) that is too large or too complex for the system to handle. The first [chars] is the module or
feature name, and the second [chars] is a value that is applied by using the route-map interface
configuration command. [dec] is an internal error code.
Recommended Action Specify a smaller and less-complicated configuration.