3-10
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Proced ures
CFGMGR Messages
Error Message BSPATCH-3-FAILED: Failed to install Boot Loader patch ([chars]).
Note This message apply only to Catalyst 3750, 3560, and 2970 switches.
Explanation The switch failed to apply a boot loader patch. [chars] is the SDRAM refresh timer
register setting.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with th e gathered
information. For more information about these online tools and about contacting Cisco, see the “Error
Message Traceback Reports” section on page 2-7.
CFGMGR Messages
This section contains the configuration manager messages.
Error Message CFGMGR-1-UNABLE_TO_SEND_RUN_CFG: unable to send running-cfg, bits:
[hex], retrying...
Note This message applies only to Catalyst 3750 and 2975 switches.
Explanation The system is unsuccessfully attempting to distribute the running configuration to the
stack member switches. [hex] is the bit representation of the switch number.
Recommended Action Find out more about the error by using the show tech-support privileged
EXEC command and by copying the error message exactly as it appears on the console or system
log and entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported
problems. For more information about these online tools and abo ut contacting Cisco, see the “Error
Message Traceback Reports” section on page 2-7.