3-38
Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide
OL-8551-04
Chapter 3 Message and Recovery Proced ures
FM Messages
Error Message FM-3-INITLABEL: Special initialization of label [dec] failed.
Note This message applies only to Catalyst 3550 switches.
Explanation The initialization of the access list hardware failed. Prioritization of routing protocol
packets above other kinds of packets might not occur on some VLANs or routed ports. [dec ] is the
label number.
Recommended Action Find out more about the error by using the show tech-support privileged
EXEC command and by copying the error message exactly as it appears on the console or system
log and entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported
problems. For more information about these online tools and abo ut contacting Cisco, see the “Error
Message Traceback Reports” section on page 2-7 for more information.
Error Message FM-3-INSERTFAIL: Insert of access-map [chars] [dec] into [chars] label
[dec] failed.
Note This message applies only to Catalyst 3550 switches.
Explanation The system ran out of CPU memory when trying to merge sections of an access map.
The first [chars] is the map name, and the second [chars] is the direction in which the map was
applied. The first [dec] is the entry number, and the second [dec] is the label number.
Recommended Action Reduce other system activity to eas e the memory demands. For example,
remove any ACLs that have been defined but are not now used. Use simpler ACLs with fewer access
control entries (ACEs). Use fewer VLANs, and remove any unneeded VLANs from the VLAN
database.
Error Message FM-3-INTTABLE: Not in truth table: VLMAP [dec] RACL [dec] Rtprot [dec]
Redir [dec] Mcb [dec] Feat [dec].
Note This message applies only to Catalyst 3550 switches.
Explanation An unrecoverable software error occurred while the software was trying to merge th e
configured input features. The first five [dec] values are internal code numbers for the results of the
VLAN map, router ACL, routing protocol selector, IP redirect settings, and the multicast boundary
configured on a Layer 3 interface. The sixth [dec] value is the feature that was being examined when
the problem was detected.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about co ntacting
Cisco, see the “Error Message Traceback Reports” section on page 2-7.