Cisco Systems 4948E manual Installing the Chassis in the Rack, Installing the Rack-Mount Brackets

Chapter 3 Installing the Switch

Rack-Mounting the Chassis

Figure 3-1 Installing the Rack-Mount Brackets

2

1

1

2

2

1

2 1 207508

1

M4 screws (4 screws per bracket)

2

Rack-mount bracket

Installing the Chassis in the Rack

To install the chassis in the rack, follow these steps:

Step 1 Have one person carefully lift and position the chassis in front of the rack.

Step 2 Position the chassis in the rack until the rack-mount bracket ears are in contact with the rack.

Tip Use a tape measure or a level to ensure that the chassis is installed level in the rack.

Step 3 Adjust the chassis up or down in the rack until two screw holes in each rack-mount bracket ear are aligned with corresponding mounting holes in the equipment rack post. Place a level on top of the chassis and verify that the chassis is not tilted in the equipment rack.

Step 4 While one person holds the chassis in place, secure the chassis to the rack with the four 10-32 x 3/4-inch or the four 12-24 x 3/4-inch Phillips-head machine screws (two on each side) that are supplied in the accessory kit.

Catalyst 4948E and Catalyst 4948E-F Switch Installation Guide

OL-21561-02 3-7