Chapter 3 Installing the Switch

Attaching the Interface Cables

Figure 3-12 Verifying the SFP Transceiver Installation

192383

Note For an optical SFP transceiver, before removing the dust plugs and making any optical connections, observe the following guidelines:

Always keep the protective dust plugs on the unplugged fiber-optic cable connectors and the transceiver optical bores until you are ready to make a connection.

Always inspect and clean the LC connector end-faces just before making any connections. See the Tip on this page for a pointer to a fiber-optic inspection and cleaning white paper.

Always grasp the LC connector housing to plug or unplug a fiber-optic cable.

Step 9 Remove the dust plugs from the network interface cable LC connectors. Save the dust plugs for future use.

Step 10 Inspect and clean the LC connector’s fiber-optic end-faces.

Tip For complete information on inspecting and cleaning fiber-optic connections, see the white-paper document at this URL:

http://www.cisco.com/en/US/tech/tk482/tk876/technologies_white_paper09186a0080254eba.shtml

Step 11 Remove the dust plugs from the SFP transceiver optical bores.

Step 12 Immediately attach the network interface cable LC connector to the SFP transceiver.

 

 

Catalyst 4948E and Catalyst 4948E-F Switch Installation Guide

 

 

 

 

 

 

OL-21561-02

 

 

3-19

 

 

 

 

 

Page 61
Image 61
Cisco Systems 4948E-F manual Verifying the SFP Transceiver Installation