Cisco Systems 6921 Before You Begin, Install Non-Lockable Wall Mount Kit for Phone

F-3
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23769-01
Appendix
ADA Non-Lockable Wall Mount Kit for 6900 Series
• One phone bracket
• One wall bracket
• Four #8-18 x 1.25-inch Phillips-head screws with four anchors
• Two M2.5 x 6 mm machine screws
• One 6-inch Ethernet cable
Before You Begin
You need these tools to install the bracket:
• #1 and #2 Phillips-head screwdrivers
• Level
• Pencil
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does
not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a
regular telephone jack. For more information about phone installation requirements and warnings, see
Setting Up the Cisco Unified IP Phone, page 3-1.
Install Non-Lockable Wall Mount Kit for Phone
Step 1 Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you
can run the Ethernet network cable to a jack nearby.
a. Hold the bracket on the wall, placing it so that the arrow on the back of the bracket is pointing up.
b. Use the level to ensure the bracket is level and use a pencil to mark the screw holes.
c. Use a #2 Phillips-head screwdriver to carefully center the anchor over the pencil mark and press the
anchor into the wall.
d. Screw the anchor clockwise into the wall until it is seated flush.
e. Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.
The following figure shows the steps to mount the wall bracket.