Cisco Systems 6921 manual IPv4 Setup Menu Options, Device Phone Phone

Chapter

IPv4 Setup Menu Options

Table 4-1 Network Setup Menu Options (continued)

Option	Description		To Change
PC Port Setup	Speed and duplex of the access port. Valid values:		1. Unlock network setup options.
	•	Auto Negotiate	2. Scroll to the PC Port Setup
	• 1000 Full—1000-BaseT/full duplex (Supported only		option and then press the Edit
			softkey.
		for Cisco Unified IP Phone 6945.)
			3. Scroll to the setting that you
	•	100 Half—100-BaseT/half duplex
			want and then press the Select
	•	100 Full—100-BaseT/full duplex
			button.
	•	10 Half—10-BaseT/half duplex	To configure the setting on multiple
	•	10 Full—10-BaseT/full duplex	phones simultaneously, enable the
	If the phone is connected to a switch, configure the port		PC Port Remote Configuration in the
			Enterprise Phone Configuration
	on the switch to the same speed/duplex as the phone, or
			(System > Enterprise Phone
	configure both to auto-negotiate.
			Configuration).
	If you change the setting of this option, you must change		Note If the ports are configured for
	the SW Port Configuration option to the same setting.		PC Port Remote
			Configuration in Unified
			CM, the data cannot be
			changed on the phone.
LLDP-MED: Switch Port	Enables and disables Link Layer Discovery Protocol		From Cisco Unified CM
	Media Endpoint Discovery (LLDP-MED) on the switch		Administration, choose
	port. Use this setting to force the phone to use a specific		Device > Phone > Phone
	discovery protocol, which should match the protocol		Configuration.
	supported by the switch. Settings include:
	•	Enabled—default
	•	Disabled

IPv4 Setup Menu Options

The IPv4 Setup menu is a submenu of the Network Setup menu. To reach the IPv4 Setup menu, select the IPv4 option on the Network Setup menu.

Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)

4-6 OL-23769-01