4-4
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23769-01
Chapter
Network Setup Menu
Network Setup Menu
The Network Setup menu provides options for viewing and making a variety of network settings.
Table 4-1 describes these options and, where applicable, explains how to change them.
For information about how to access the Network Setup menu, see the “Displaying a Configuration
Menu” section on page 4-2.
For information about the keys you can use to edit options, see the “Editing Values” section on page 4-3.
Table 4-1 Network Setup Menu Options
Option Description To Change
IPv4 Setup In the IPv4 Setup submenu, you can do the following:
Enable or disable the phone to use the IP address that
is assign by the DHCP server.
Manually set the IP Address, Subnet Mask, Default
Routers, DNS Server, and Alternate TFTP servers.
For more information on the IPv4 address fields, refer to
Table 4-2.
Scroll to IPv4 Setup and press
Select.
Host Name Unique host name that the DHCP server assigned to the
phone. Display only—Cannot configure.
Domain Name Name of the Domain Name System (DNS) domain in
which the phone resides.
1. Set the DHCP Enabled option to
No.
2. Scroll to the Domain Name
option, press the Edit softkey,
and then enter a new domain
name.
3. Press the Apply softkey, then
press Save.
Operational VLAN ID Auxiliary Virtual Local Area Network (VLAN)
configured on a Cisco Catalyst switch in which the phone
is a member.
If the phone has not received an auxiliary VLAN, this
option indicates the Administrative VLAN.
If neither the auxiliary VLAN nor the Administrative
VLAN are configured, this option defaults to a VLAN ID
of 4095.
Display only—Cannot configure.
The phone obtains its Operational
VLAN ID via Cisco Discovery
Protocol (CDP) from the switch to
which the phone is attached. To
assign a VLAN ID manually, use the
Admin VLAN ID option.
Admin. VLAN ID Auxiliary VLAN in which the phone is a member.
Used only if the phone does not receive an auxiliary
VLAN from the switch; otherwise it is ignored.
1. Scroll to the Admin. VLAN ID
option, press the Edit softkey,
and then enter a new Admin
VLAN setting.
2. Press the Apply softkey, then
press Save.