Chapter 2
Completing the Configuration
Step 6 Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the console port:
The virtual terminal password is used to protect access to the router over a network interface.
Enter virtual terminal password: guessagain
Step 7 Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]:
Step 8 The summary of interfaces is displayed.
Current interface summary
Controller | Timeslots | Status | |||
T1 | 0/0 | 24 | 23 | pri/channelized | Administratively up |
T1 | 0/1 | 24 | 23 | pri/channelized | Administratively up |
T1 | 0/2 | 24 | 23 | pri/channelized | Administratively up |
T1 | 0/3 | 24 | 23 | pri/channelized | Administratively up |
Interface | OK? Method | Status | Protocol | ||
FastEthernet0/0 | 172.18.46.74 | YES NVRAM | up | up | |
FastEthernet0/1 | 150.0.1.0 | YES NVRAM | up | up | |
Serial0/0:0 | unassigned | YES | NVRAM | up | up |
Serial0/1:0 | unassigned | YES | NVRAM | up | up |
Step 9 Specify the interface to be used to connect to the network management system.
Enter interface name used to connect to the
management network from the above interface summary:FastEthernet0/0
Step 10 You are then prompted to configure the specified interface.
Configuring interface FastEthernet0/0:
Use the 100
Operate in
Configure IP on this interface? [yes]:no
Completing the Configuration
When you have provided all the information prompted for by the setup command facility, messages similar to the following appear:
The following configuration command script was created:
!
hostname
enable secret 5 $1$kA4t$2LpzAVTQADpqTMeqAIG3F0
|
| enable password guessme | |||
|
| line vty 0 4 | |||
|
| password guessagain | |||
|
| no | |||
|
| ! |
|
|
|
|
| no ip routing | |||
|
| ! |
|
|
|
|
| interface FastEthernet0/0 | |||
|
| no shutdown | |||
|
| Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
| ||
