Cisco Systems 78-13983-04 manual Ppp mux pid integer

Chapter 5 Command Reference

ppp mux pid

ppp mux pid

To set the default receiving PPP protocol ID, use the ppp mux pid command in interface configuration mode. To remove this configuration, use the no form of this command.

pppmux pid integer

	no ppp mux pid
Syntax Description	integer	The default value of the PPP protocol ID. Possible values are 0 through
		65534.

Defaults

Command Modes

Command History

The default is 33 (0x21), which is the IP protocol.

Interface configuration

ReleaseModification

12.2(8)MC2 This command was introduced.

Usage Guidelines

Examples

Related Commands

To use this command, you must first enable PPP multiplexing/demultiplexing.

The following example sets the default PPP protocol ID to 8.

ppp mux pid 8

Command	Description
ppp mux	Enables PPP multiplexing/demultiplexing
ppp mux delay	Sets the maximum delay.
ppp mux frame	Sets the maximum length of the PPP superframe.
ppp mux subframe count	Sets the maximum number of subframes in a superframe.
ppp mux subframe length	Sets the maximum length of the PPP subframe.
show ppp mux	Displays PPP mux counters for the specified multilink interface.

Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide

78-13983-04 5-11