Cisco Systems 78-13983-04 Command Reference

CHAPTER

5-1

Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide

78-13983-04

Command Reference

This chapter contains information about commands that were introduced specifically in support of the

MWR 1900:

The following commands have been added or changed with this release:

•clear ppp mux

•mode y-cable

•ppp mux

•ppp mux delay

•ppp mux frame

•ppp mux pid

•ppp mux subframe length

•ppp mux subframe count

•redundancy

•show ppp mux

•show redundancy

•standalone

•standby use-interface

The following commands were not altered but have been included for your convenience:

•clear ip rtp header-compression

•ip rtp compression-connections

•ip rtp header-compression

•show ip rtp header-compression

Contents

Main Page Page Page Page Page About This Guide Objectives Audience Organization Document Conventions Additional Information Related Documentation Obtaining Documentation World Wide Web Documentation CD-ROM Obtaining Technical Assistance Cisco.com Technical Assistance Center Contacting TAC by Using the Cisco TAC Website Contacting TAC by Telephone Overview of the MWR 1900 Benefits Software Features Cisco IOS Software Network Processor Software PPP Multiplexing/Demultiplexing RTP/UDP Header Compression Redundancy Support HSRP MIB Support Limitations and Restrictions First-Time Configuration Before You Begin Understanding Boot Images Understanding Interface Numbering Page Before Starting Your Router Using the Setup Command Facility Configuring Global Parameters 2-4 Step 2 When the following message appears, enter yes to begin the initial configuration dialog: Step 3 Enter a host name for the router (this example uses 1900-1): viewing the configuration: encrypted (less secure) and can be seen when viewing the configuration: Completing the Configuration Page Cisco IOS Software Basics Getting Help Understanding Command Modes Undoing a Command or Feature Saving Configuration Changes Page Configuring with the Command-Line Interface Before You Begin Verifying the Version of Cisco IOS Software Configuring the Host Name and Password Configuring Loopback Interfaces Configuring Fast Ethernet Interfaces Configuring the FE Interface IP Address Setting the Speed and Duplex Mode Configuring Routing Protocol Attributes Configuring PIM Configuring HSRP Support Enabling the FE Interface Configuring Multilink Interfaces Configuring Multilink PPP Configuring IP Address Assignment Configuring PPP Multiplexing Configuring RTP/UDP Compression Configuring Routing Protocol Attributes Configuring PIM Configuring T1 and E1 Interfaces Configuring T1 Interfaces Configuring E1 Interfaces Configuring QoS Attributes Creating a Class Map Creating a Policy Map Page Assigning a QoS Boilerplate to an Interface Configuring Redundancy Redundant MWR 1900s Stand-Alone MWR 1900 4-18 Saving Configuration Changes Step 1 Exit configuration mode. Note You can press Ctrl-z in any mode to immediately return to enable mode (Router#), instead of entering exit, which returns you to the previous mode. outages. 4-19 4-20 4-21 Notes Monitoring and Managing the MWR 1900 Show Commands for Monitoring the MWR 1900 Page Command Reference clear ip rtp header-compression clear ppp mux ip rtp compression-connections ip rtp header-compression Page mode y-cable ppp mux ppp mux delay ppp mux frame ppp mux pid ppp mux subframe length ppp mux subframe count redundancy show ip rtp header-compression Page show ppp mux Page show redundancy Page standalone standby use-interface Page Page INDEX C D E G H I L N O P R T U V Y