Chapter 12: - Using Cisco Tools from a Command Line

How to Use the Compare Registries Utility from a Command Line

To Run the Compare Registries Utility from a Command Line

To run the Compare Registries utility in interactive mode from a command line:

Step 1 From a command prompt on a Support Tools node, navigate to <support_tools_root>.

Step 2 Enter regcompare.

To view a list of systems defined in the current system's system list, use the systemlist command. To view connection status for systems in the list, use the systemlist /check command.

Step 3 Enter commands as described in the Command Line Options section below.

Note: For additional information on basic Web Tools command line use, including system selection options and command-line mode vs interactive mode see Using Cisco Common Tools from a Command Line (page 125).

Using the Compare Registries Utility from a Command Line

Command:

Description:

Example:

cmdhelp, chelp

Displays a list of commands specific to this utility.

>cmdhelp

 

Note: Using Help or ? also displays this list, but includes several

 

 

additional ICM commands (e.g., echo, error_stop) not used by

 

 

this utility.

 

/?

Displays syntax for a specified command.

><command> /?

appserver

Specifies the system on which the utility should run. If not

><app_servername> /

 

specified, the utility is run on the local system.

<options>

system

Specifies the target system the utility should run against. If not

> /system <host_name> /

 

specified, the utility is run against the local system.

<options>

localhost

Sets the network address of name of the target node to the local

>localhost

 

host.

 

 

Note: By default, unless a different system is specified (using the

 

 

system command) the local host is assumed to be the target system.

 

Cisco Support Tools User Guide for Cisco Unified Software Release 2.1(1)

140

Page 154
Image 154
Cisco Systems 2.1(1) manual To Run the Compare Registries Utility from a Command Line, 140