Cisco Systems 2.1(1) manual To Run the Registry Utility from a Command Line, 137

Chapter 12: Using Cisco Tools from a Command Line

How to Use the Registry Utility from a Command Line

Use the Registry utility to:

•View the ICM Windows registry settings for the current system

•Save registry settings to a file

To Run the Registry Utility from a Command Line

To run the Registry utility in interactive mode from a command line:

Step 1 From a command prompt on a Support Tools node, navigate to <support_tools_root>.

Step 2 Enter registry.

To view a list of systems defined in the current system's system list, use the systemlist command. To view connection status for systems in the list, use the systemlist /check command.

Step 3 Enter commands as described in the Command Line Options section below.

Note: For additional information on basic Web Tools command line use, including system selection options and command-line mode vs interactive mode see Using Cisco Common Tools from a Command Line (page 125).

Using the Registry Utility from a Command Line

Table 8: Command Line Options

Command:	Description:	Example:
cmdhelp, chelp	Displays a list of commands specific to this utility.	>cmdhelp
	Note: Using Help or ? also displays this list, but includes several
	additional ICM commands (e.g., echo, error_stop) not used by
	this utility.
/?	Displays syntax for a specified command.	><command> /?
appserver	Specifies the system on which the utility should run. If not	><app_servername> /
	specified, the utility is run on the local system.	<options>
system	Specifies the target system the utility should run against. If not	> /system <host_name> /
	specified, the utility is run against the local system.	<options>
localhost	Sets the network address of name of the target node to the local	>localhost
	host.
	Note: By default, unless a different system is specified (using the
	system command) the local host is assumed to be the target system.

Cisco Support Tools User Guide for Cisco Unified Software Release 2.1(1)

137