5-21
Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide
78-13983-04
Chapter5 Command Reference
standalone
standalone
To specify that the MWR 1900 is being used in a stand-alone configuration (which impacts the relays
on the VWIC), use the standalone command. To use the MWR 1900 in a redundant configuration, use
the no form of this command.
[no] standalone
Syntax Description This c ommand has no attributes.
Defaults By default, the MWR 1900 is configured to be used in a redundant configuration (no standalone) and
the relays are open.
Command Modes Y-cable configuration
Command History
Usage Guidelines Issuing the standalo ne command closes the relays on the VWICs installed in the MWR 1900.
Examples The following example closes the relays so that the MWR 1900 can be used as a stand-alo ne device.
standalone
Related Commands
Release Modification
12.2(8)MC2 This command was introduced.
Command Description
mode y-cable Invokes y-cable mode.
standby use-interface Specifies the interfaces to be used for health and revertive interfaces.