Chapter 2 First-Time Configuration
Where to Go Next
no ip address
!
interface FastEthernet0/1 shutdown
no ip address
!
end
To complete your router configuration, do the following:
Step 1 A setup command facility prompt asks if you want to save this configuration.
[0]Go to the IOS command prompt without saving this config.
[1]Return back to the setup without saving this config.
[2]Save this configuration to nvram and exit.
Enter your selection [2]:
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
If you answer no, the configuration information you entered is not saved, and you return to the router enable prompt. Type setup to return to the System Configuration Dialog.
If you answer yes, the configuration is saved and you are returned to the EXEC prompt.
Step 2 When the messages stop displaying on your screen, press Return to get the command line prompt.
The
Where to Go Next
At this point you can proceed to the following:
•Chapter 3, “Cisco IOS Software Basics” to learn how to use the CLI to configure additional features.
•Chapter 4, “Configuring with the
•The Cisco IOS software configuration guide and command reference publications for more advanced configuration topics.The Cisco 10000 ESR Quality of Service Documents for more information on configuring QoS. These publications are available on the Documentation
Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide
| ||
|
