5-4
Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide
78-13983-04
Chapter 5 Command Reference
ip rtp compression-connections
ip rtp compression-connections
To specify the total number of Real-Time Transport Protocol (RTP) header compression conn ections
that can exist on an interface, use the ip rtp compression-connections interface configuration
command. To restore the default value, use the no form of this command.
ip rtp compression-connections number
no ip rtp compression-connections
Syntax Description
Defaults 16 connections
Command Modes Interface configuration
Command History
Examples The following example changes the number of RTP header compression connections suppo rted to 150:
interface serial 0
encapsulation ppp
ip rtp header-compression
ip rtp compression-connections 150
Related Commands
number Number of RTP header compression connections the cache supports, in the
range from 3 to 600. The default is 16 connections.
Release Modification
11.3 This command was introduced.
12.0(7)T For PPP and High-Level Data Link Control (HDLC) encapsulation, the
maximum number of connections increased from 256 to 1000.
For Frame Relay encapsulation, the maximum number of connections
increased to 256. The maximum value for Frame Relay is fixed, not
configurable.
12.1(4)E This command was supported on Cisco 7100 series routers.
12.2(8)MC2 The upper limit for the MWR 1900 is set at 600.
Command Description
ip rtp header-compression Enables RTP header compression.
show ip rtp
header-compression
Displays RTP header compression statistics.