Cisco Systems UBR7100E manual System LEDs, Cisco uBR7111 System Leds

Chapter 4 System Startup

Starting the System

System LEDs

Many of the interface LEDs do not go on until you have configured them. To verify correct operation of each interface, complete the first-time startup procedures and configuration, and then use the LEDs to check the status of the interfaces.

The LEDs indicate the status of the router. The CPU reset button that you to reset the entire system. The LEDs are shown in Figure 4-1and Figure 4-2, and are described in Table 4-1.

Caution To prevent system errors and problems, use the CPU reset button only at the direction of your service representative.

Figure 4-1 Cisco uBR7111 System LEDS

ACT ACT			PWR
Active		Active
			Power
Link		Link
			Sys Rdy
LNK LNK
			SYS
2	1
			RDY

5				SLOT 0	SLOT 1
				ACT
						PWR
I	DS0		FE 0/0	FE 0/1
	RF	DS0				SYS
					CONS	AUX RDY
					US0
					EN
					uBR7114
		DS0				EN
	RF	DS0				Card Enable
DS0 RF					US0
					U0 Enable

Figure 4-2 Cisco uBR7114 System LEDs

ACT ACT			PWR
Active		Active
			Power
Link		Link
			Sys Rdy
LNK LNK
			SYS
2	1
			RDY

37403

5				ACT	SLOT 0	SLOT 1
							PWR
I	DS0		FE 0/0	FE 0/1
	RF	DS0					SYS
			US3			CONS	AUX RDY
			US2	US1
						US0
						EN
						uBR7114
			DS0				EN
	RF	DS0					Card Enable
DS0 RF			US3			US0
		U3 Enable				U0 Enable
				US2	US1
			U2 Enable			U1 Enable

36455

Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide

OL-5916-01 4-3