Cisco Systems UBR7100E manual Organization, Related Documentation, Chapter Description, Viii

Preface

Organization

Organization

The major sections of this guide are as follows:

Chapter	Description
Chapter 1, “Product Overview”	Describes the Cisco uBR7100 series universal broadband
	router and its major features and interfaces.
Chapter 2, “Preparing for Installation”	Describes the steps required to prepare a site before installing
	the Cisco uBR7100 series router.
Chapter 3, “Installing Cisco uBR7100	Provides instructions to install the Cisco uBR7100 series
Series Universal Broadband Routers”	router and to connect its network interface cables.
Chapter 4, “System Startup”	Describes the procedure for the initial startup of the system.
Chapter 5, “Troubleshooting the	Provides basic troubleshooting procedures for the hardware
Installation”	installation.
Chapter 6, “Maintenance”	Describes recommended maintenance procedures.
Appendix A, “System Specifications”	Contains the physical specifications and power requirements
	of the router.
Appendix B, “Manufacturers for	Lists vendors for the auxiliary equipment that is normally
Headend Provisioning Requirements”	required for a headend installation.
Appendix C, “Cable Specifications”	Provides cabling information and pinout information for the
	router.
Appendix D, “Frequency Allocation	Provides the standard frequency allocation channel plans.
Tables”
Appendix E, “Site Log”	Provides a sample log sheet that can be used to track
	maintenance and other changes that are done to the equipment.

Related Documentation

Your Cisco uBR7100 series router and the Cisco IOS software running on it contain extensive features and functionality, which are documented in the following resources:

•For international agency compliance, safety, and statutory information for WAN interfaces for Cisco uBR7100 series routers, refer to the regulatory compliance and safety information document that shipped with your router.

•For information on installing and replacing field-replaceable units (FRUs), refer to the individual document for each FRU.

•For information about replacing SDRAM see Memory Replacement Instructions for the Network Processing Engine or Network Services Engine and Input/Output Controller at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/core/7206/fru/memory/index.htm

•For information on using the flash disk, see the “Flash Memory Card Usage” section on page 6-5and the Using the Flash Disk document at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/core/7200vx/72vxfru/5819fdsk.htm

Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide

viii OL-5916-01