Cisco Systems WSC3750X24TS specifications 2-38, 53 Removing a XENPAK Module

Chapter 2 Switch Installation

Installing and Removing XENPAK Modules (Catalyst 3750G-16TD Switch)

Removing a XENPAK Module

To remove a XENPAK module, follow these steps:

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

Step 2 Disconnect the cable from the XENPAK module. For fiber-optic modules, install the optical bore dust plugs.

Step 3 Loosen the two captive installation screws that secure the XENPAK module in the slot.

Step 4 Carefully pull on the two captive installation screws to disconnect the XENPAK module from the slot. Step 5 Grasp the edges of the XENPAK module, and carefully slide it out of the slot, as shown in Figure 2-53.

Figure 2-53 Removing a XENPAK Module

TX RX

Catalyst

1

3750

series

104574

1

1

2

Optical bore dust plug 2 Captive installation screw

Catalyst 3750 Switch Hardware Installation Guide

2-38 OL-6336-07