Cisco Systems WSC3750X24TS specifications Switch Installation

Chapter 2 Switch Installation

Installing and Removing XENPAK Modules (Catalyst 3750G-16TD Switch)

Step 3 Unlock and remove the SFP module, as shown in Figure 2-49.

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow instrument to open the bale-clasp latch.

Figure 2-49 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver

	13	14	15	16
					17	18
							19
13X								20
									21
										22
											23
												24
												23X
14X
												2

Catalyst

1

3750

SERIES

2

86554

1

1

Bale clasp

Step 4 Grasp the SFP module between your thumb and index finger, and carefully remove it from the module slot.

Step 5 For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.

Step 6 Place the removed SFP module in an antistatic bag or other protective environment.

Installing and Removing XENPAK Modules (Catalyst 3750G-16TD Switch)

These sections describe how to install and remove XENPAK modules:

•Removing SFP Modules from SFP Module Slots, page 2-34

•Removing a XENPAK Module, page 2-38

XENPAK modules are inserted into the XENPAK module slot on the front panel of the Catalyst 3750G-16TD switch. These field-replaceable transceiver modules provide 10-Gigabit interfaces.

Note The 10-Gigabit Ethernet XENPAK modules are referred to as 10-Gigabit Ethernet module ports in the switch software documentation.

Catalyst 3750 Switch Hardware Installation Guide

OL-6336-07 2-35