Cisco Systems WSC3750X24TS 2-37, 51 Removing the XENPAK Module Slot Cover, series 104764

Chapter 2 Switch Installation

Installing and Removing XENPAK Modules (Catalyst 3750G-16TD Switch)

Step 2 Remove the two Phillips-head retaining screws from the XENPAK module slot cover, and store them for later use.

Step 3 Remove the cover, as shown in Figure 2-51.

Figure 2-51 Removing the XENPAK Module Slot Cover

1

Catalyst 3750

1

series

104764

1

2

Phillips-head screw 2 Module slot cover

Step 4 Remove the XENPAK module from the protective packaging.

Step 5 Align the XENPAK module with the guide rails inside the module slot, and slide the module into the opening until the back of the XENPAK faceplate is flush with the switch faceplate. (See Figure 2-52.)

Figure 2-52 Installing a XENPAK Module in the Catalyst 3750G-16TD Switch

TX RX

Catalyst 3750

1

series

104573

1

2

1

Optical bore dust plug

2

Captive installation screw

Step 6 Secure the XENPAK module in place by tightening the two captive installation screws. Do not overtighten the captive screws.

Catalyst 3750 Switch Hardware Installation Guide

OL-6336-07 2-37