Citation Stereo Receiver owner manual Operating the Citation, Turning On and Off

Operating the Citation 5.0

Operating the Citation 5.0

After installing and configuring the Citation 5.0, and making any desired initial settings, normal operation is a simple matter, thanks to its powerful microprocessor and a sophisticated remote con- trol that allows most changes to be accomplished by pressing one button. Please note, however, that due to the large number of functions and features controlled by the system microprocessor, there will occasionally be slight delays in executing commands you have given it, not unlike those experienced when using a computer.

Turning On and Off

The Master Power button 1 should remain in the ON position under normal circumstances. Simply press it in until you hear a click, and release. A green Standby LED 6 will illuminate, indicating the 5.0 is in its Standby mode, and is ready to operate.

The 5.0 may be turned fully on by either pressing the large Standby button 2 just above the Master Power button 1 on the front panel, or by pressing either the Watch button • or the Listen button Ä on the remote control. Pressing any of the six Analog Input or six Digital Input direct-address buttons under the sliding door on the remote control will also turn the 5.0 on, while selecting the program whose number was pressed. Note that pressing the Standby button Œ on the remote control WILL NOT turn the 5.0 on, although it will return it to the Standby condition when your listening or viewing session is completed.

As the 5.0 turns on, the word in the Power Indicator 5 on the front panel will glow a soft blue, the green standby indicator will extinguish, and a welcome screen (Figure OSD-16) will briefly appear on the video screen, if it is on. A similar display will also appear on the front panel (Figure FPD-1), changing in a few seconds to a status report (Figure FPD-2) indicating the program selected, its source, the Surround mode selected and present volume setting.

C I T A T I O N 5 . 0

A u d i o V i d e o P r o c e s s o r

	x x . x x
	O W N E D	B Y
C i t a t i o n C o n s u m e r
	Figure OSD-16
Citation 5.0			Prog	7 : DVD
Rev X.XX			*Pro	Logic*	Vol=49
Figure FPD-1				Figure FPD-2

To put the 5.0 back in the Standby mode, either press the front panel Standby button 2 or press the Standby button Œ on the remote control. A message of POWER OFF Ð STANDBY will appear briefly both on the on-screen display (Figure OSD-17) and the front panel display (Figure FPD-3). The Power Indicator 5 will go out, and the green Standby LED 6 will light.

44